"Brand screw" Fu plastic cleaning materials based on the efficient surfactant technology, by a variety of security level additives formulated with a non-abrasive, non-corrosive, high performance thermoplastic purging compound suitable for cleaning plastic injection molding, extrusion and blow molding molding machine screw and barrel, to remove coke, black spots, color point; Switch Color, refueling great helper to avoid demolition screw; addition, regular use of screw cleaning materials for washing machine, prevent the machine pollution and plot The formation of carbon. The new formula developed by the color change time is short, with less, high efficiency, good effect, not to hurt the screw stimulate toxic odor released. The RoHS Directive detection. Appearance: white columnar applicable temperature: 180 ℃ ~ 360 ℃ Scope: transparent product-specific (PC, PMMA, PS, PP, etc.) Dosage: with screw size and process depending on usage: directly added until the cleaning, changing color, refueling end of the method used in the injection molding machine: first rule out the barrel before material clean, clean the hopper to prevent residual toner material or new material contamination before, then screw cleaning of the appropriate proportion of the material is pressed into the barrel (if refueling new material technology to adjust temperature), melt, injection, until the color of the emitted material strips into uniform (cleaning material color and the screw the same), you can stop adding cleaning material, and finally adding a small amount of new material to be produced material The pipe cleaning materials discharged on completion of the cleaning work to normal production. Extruder (pelletizing machine, film blowing machine, sheet extruder, pipe molding machine, blow molding machine, etc.) use the method: First, rule out the barrel before material clean, increase the temperature of the die 10 to 20 degrees, cleaning the hopper, new material to prevent residual toner or before feeding pollution, low-speed rotation of the screw and then the appropriate proportion screw cleaning material (if refueling, new material technology to adjust temperature) extrusion until the extrusion of material strips The color becomes uniform (same color and the screw cleaning material), you can stop adding cleaning material, adding a small amount of new material last barrel cleaning materials discharged on the completion of the cleaning work to being normal production. Screw speed (in the low-speed and high-speed switching equipment load conditions allowed transform or replace the filter or remove the die by hand washing), to improve the cleaning efficiency! Weight (depending on the machine recency, convert color shades and operating habits, the following dosage for reference only!) Extruder screw diameter / MM clamping force of the injection molding machine specifications / T injection molding machine Injection volume / Ann screw cleaning materials / Kg Remark 20 to 45 80 3.6 0.5 1.0 45 to 75 120 0.8 to 2.0 500 18 2.0 to 3.0 80 to 140 800 36 3.0 to 4.0 1,250,180 4.0 ~ 5.0 3,000,360 5.0 ~ 15.0 Note: * This product is non-hazardous products, non-toxic, dust-free, non-flammable. * Non-sun and rain, and the need to pay attention to prevent acid and other impurities are mixed. * Storage should be stored in a warehouse 0 ~ 49 ℃, keep ventilated, dry, cool, non-direct sunlight or exposed to outdoor. Used in single, twin screw extruder, the feeding rate should be moderate, the adjustment of the rotational speed should be in the load within the device, to prevent damage to the device or card material. Shelf life: 1 year