"Brand screw" Fu plastic cleaning materials based on the efficient surfactant technology, by a variety of security level additives formulated with a non-abrasive, non-corrosive, high performance thermoplastic purging compound suitable for cleaning plastic injection molding, extrusion and blow molding molding machine screw and barrel, to remove coke, black spots, color point; Switch Color, refueling great helper to avoid demolition screw; addition, regular use of screw cleaning materials for washing machine, prevent the machine pollution and plot The formation of carbon. The new formula developed by the color change time is short, with less, high efficiency, good effect, not to hurt the screw stimulate toxic odor released. Detection through the EU ROHS Directive. Appearance: the white columnar applicable temperature: 250-360 ° C Scope: modified granulation or high-temperature injection molding product usage: With the screw size and process depending on usage: Note that the feed rate, the current should be controlled in the range of 60% of the full load injection molding machine Usage: First rule out the barrel before material clean, clean the hopper, new material to prevent residual toner or material contaminated before cleaning, then the appropriate proportion of the screw material pressed into the feed tube (if refueling Press new material technology to adjust temperature), melt, increase the back pressure of the air injection (minutes), until the color of the emitted material strips into uniform (the same color and the screw cleaning material) to stop adding the cleaning material Finally, add a small amount to the production of new material in the barrel cleaning materials discharged on completion of the cleaning work to normal production. Extruder (pelletizing machine, film blowing machine, sheet extruder, pipe molding machine, blow molding machine, etc.) use the method: First, rule out the barrel before material clean, increase the temperature of the die 10 to 20 degrees, cleaning the hopper, new material to prevent residual toner or before feeding pollution, low-speed rotation of the screw and then the appropriate proportion screw cleaning material (if refueling, new material technology to adjust temperature) extrusion until the extrusion of material strips The color becomes uniform (same color and the screw cleaning material), you can stop adding cleaning material, adding a small amount of new material last barrel cleaning materials discharged on the completion of the cleaning work to being normal production. Screw speed (in the low-speed and high-speed switching equipment load conditions allowed transform or replace the filter or remove the die by hand washing), to improve the cleaning efficiency! Weight (depending on the machine recency, convert color shades and operating habits, following dosage is for reference only!) 1 oz = 28 g (for cleaning extrusion equipment use reference implementation) extruder screw diameter / MM 20 to 45 80 3.6 0.5 1.0 45 to 75 120 0.8 - 2.0 500 18 2.0 to 3.0 80 to 140 800 36 3.0 to 4.0 clamping force injection molding machine specifications / T injection molding machine Injection volume / security screw cleaning material / Kg Remarks 1250 180 4.0 ~ 5.0 3,000,360 10.0 ~ 15.0 Note: * This product is non-dangerous goods, non-toxic, non-dust, non-flammable. * Non-sun and rain, and the need to pay attention to prevent acid and other impurities are mixed. * Storage should be stored in a warehouse 0 ~ 49 ℃, keep ventilated, dry, cool, non-direct sunlight or exposed to outdoor. Used in single, twin screw extruder, the feeding rate should be moderate, the adjustment of the rotational speed should be in the load within the device, to prevent damage to the device or card material. Shelf life: 1 year